Community of fiber, mobile and ADSL usersToday I wanted to start Putty and read the password with my serial USB interface, but there were no pins that I could have set the interface to according to these instructions Extract GPON and SN password from ONT Zte F601.I guess I can't just get the password from Wallapop, since the password isn't stored there.I don't think you can get an old modem for €3.90 on Wallapop, as the password is not stored there.What can I do now?To know where to go, do you have Smart fiber or NEBA fiber?If it is Smart to configure another ONT you only need the SN and that the new ONT/Router supports the change of SNThe SN is on the sticker behind the ONT FAQ: Configurations and technical solutions for Digi: own router, telephony, etc.I use NEBA - the maximum capacity here is 1Gbit, not 10. I have already replaced the router with a Fritzbox, all that remains now is to replace the modem.For this I need the ONT in the Fritzbox configuration.Even so, there are smart fiber zones that do not have 10Gbit, so it is not clear to me what type of network you have.Even so, configuring the Fritzbox as a smart fiber is trivial, try changing the SN with the ONT to see if it connects Hello @Gonzalichu As they tell you, it seems that in smart fiber…Apart from what has been said, having a photo of the other side of the plate would not be bad, since there are welds that can only be seen on the other side and it looks like they are silk-screened.Ok, I'll add it as soon as I can turn off the internet.It looks like they are the 5 connection points that are together at the bottom left of your photo, the square and the 4 circles.If it doesn't have pins on the other side (which it doesn't seem to), you can try stripped wires and tape to hold them down so you don't have to go around desoldering to find the hole.Moderators |Standards |Legal information |We enter for affiliated purchases